Panasonic ZEQUO 2200 Operating Instructions Manual page 440

46. Packet Storm Commands
 Example
To configure the traffic log state on the Switch:
Zxxx0:admin# config traffic control log state enable
Command: config traffic control log state enable
Success.
Zxxx0:admin#
46.4. config traffic trap
 Description
This command is used to configure whether storm control notification will be generated or
not while traffic storm events are detected by a SW traffic storm control mechanism.
A traffic control trap is active only when the control action is configured as
shutdown. If the control action is drop there will no traps issue while storm
event is detected.
 Format
config traffic trap [none | storm_occurred | storm_cleared | both]
 Parameters
none none - No notification will be generated when storm event is detected or cleared.
storm_occurred
A notification will be generated when a storm event is detected.
storm_cleared
A notification will be generated when a storm event is cleared.
both A notification will be generated both when a storm event is detected and cleared.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure a traffic control trap:
440