Delete Snmp - Panasonic ZEQUO 2200 Operating Instructions Manual

<auth_string 32>
Specify the authentication string. If v1 or v2 is specified, the auth_string presents the
community string, and it must be one of the entries in the community table. If v3 is
specified, the auth_string presents the user name, and it must be one of the entries in the
user table.
 Restrictions
Only Administrator-level users can issue this command.
 Example
To create a recipient of an SNMP operation:
Zxxx0:admin#create snmp host 10.48.74.100 v3 noauth_nopriv initial
Command: create snmp host 10.48.74.100 v3 noauth_nopriv initial
Success.
Zxxx0:admin#

53.17. delete snmp

 Description
This command is used to delete a recipient of an SNMP trap operation.
 Format
delete snmp [host <ipaddr> | v6host <ipv6addr>]
 Parameters
host Specify the IP address of the SNMP host recipient to be deleted.
<ipaddr>
Specify the IP address of the SNMP host recipient to be deleted.
v6host Specify the IPv6 address of the SNMP host recipient to be deleted.
<ipv6addr>
Specify the IPv6 address of the SNMP host recipient to be deleted.
 Restrictions
Only Administrator-level users can issue this command.
 Example
To delete a recipient of an SNMP trap operation:
53. SNMPv1/v2/v3 Commands
517