Panasonic ZEQUO 2200 Operating Instructions Manual page 687

None.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To clear the WAC default redirect path:
Zxxx0:admin#config wac clear_default_redirpath
Success.
Zxxx0:admin#
68.8. config wac virtual_ip
 Description
This command is used to configure the WAC virtual IP address. When virtual IP is
specified, the TCP packets sent to the virtual IP will get a reply. If virtual IP is enabled,
TCP packets sent to the virtual IP or physical IPIF's IP address will both get the reply.
When virtual IP is set 0.0.0.0, the virtual IP will be disabled. By default, the virtual IP is
0.0.0.0. The virtual IP will not respond to any ARP requests or ICMP packets. To make
this function work properly, the virtual IP should not be an existing IP address. It also
cannot be located on an existing subnet.
 Format
config wac virtual_ip {<ipaddr>}
 Parameters
<ipaddr>(Optional) Specifies the IPv4 address of the virtual IP.
 Restrictions
Only Administrator, Operator and Power-User level users can issue this command.
 Example
To configure the WAC virtual IP address used to accept authentication requests from
unauthenticated hosts:
Zxxx0:admin# config wac virtual_ip 1.1.1.1
Command: config wac virtual_ip 1.1.1.1
Success.
Zxxx0:admin#
68. Web-based Access Control (WAC) Commands
687