Avaya Communication Manager Administrator's Manual page 388

Managing Announcements
Managing VAL Announcements Using the SAT
Deleting individual VAL announcement files
using the SAT
To delete the announcement named Closed:
1
At the SAT, type remove file board board-location /annc/filename.wav and press
For example, to delete the announcement, type:
remove file board 01A11 /annc/Closed.wav
NOTE:
Filenames are case-sensitive and require the .wav file extension.
The
on the VAL circuit pack, and
Deleting all VAL announcements on a circuit
pack using the SAT
To delete all of the announcement files on the VAL circuit pack:
1
At the SAT, type busyout board board-location and press
Ensure that the command is successful.
NOTE:
When the VAL board is busied out,
2
At the SAT, type erase announcements board board-location and press
CAUTION:
This command deletes the specified announcement file in both RAM and FLASH
memory. The board firmware ignores the protect flag (Pro field) when erasing the
announcement files.
3
At the SAT, type list directory board and press
4
Verify that there are no files listed.
NOTE:
The announcement directory on the TN2501AP or G700 Media Gateway is /annc.
5
Type list integrated-annc-boards and press
Check the list to see that the announcement was deleted. The Length in Seconds field should show
0.
388
portion of the command directs the system to the announcement subdirectory
/annc
/Closed.wav
•
both the RSCL and ethernet ports are busied out.
•
firmware takes down the ethernet link.
•
FTP is disabled because the ethernet link is down.
•
announcements on that circuit pack cannot play.
Administrator's Guide for Avaya Communication Manager
indicates to delete the filename
.
ENTER
.
ENTER
.
ENTER
.
ENTER
.
Closed.wav
.
ENTER
November 2003