Avaya Communication Manager Administrator's Manual page 275

14
Set the
MMI Cabling Board
circuit pack recorded in step 2). This must be the slot for port B of the Y-cable.
15
The
MMI Interface
Figure 38: Signaling-Group screen (Page 1 of 5)
change signaling-group 6
Group Number: 6
Trunk Group for Channel Selection:
1
Enter add signaling-group next and the signaling-group screen appears.
2
Change
3
Change
circuit pack, for example: 1B0516).
4
The Max Number of NCA TSC
5
The Max Number of GA TSC
6
Trunk Group for NCA TSC
7
Trunk Group for Channel Selection
8
Logoff the terminal and then log back on the terminal to view your changes.
Troubleshooting
To determine ESM link status, enter the following commands from the system administration terminal:
1
Status esm
2
Status signaling-group
3
List MMI
NOTE:
When you move ESM circuit packs, you MUST remove the DS1 and signaling group
translations. You cannot use the
When a vector is used to route video (56K/64K) calls to a hunt group comprised of data extensions, the
vector must have the multimedia field set to n. This field causes multimedia calls routed through the
vector to receive early answer treatment prior to processing the vector steps. This provides a talk path to
the caller for announcements or immediate conversation with an agent and starts network billing for the
incoming call when vector processing begins.
Administrator's Guide for Avaya Communication Manager
November 2003
field to xxxxx (where
field ESM appears.
SIGNALING GROUP
Associated Signaling? y
Primary D-Channel: 01C0916
Supplementary Service Protocol: a
Associated Signaling field to y.
Primary D-Channel Port field to xxxx16 (where
default is 0.
default is 0.
____ (leave blank)
is the location of the TN787 MMI
xxxxx
Max number of NCA TSC: 0
Max number of CA TSC: 0
Trunk Group for NCA TSC:
xxxx is the address of the TN2207 PRI
____ (leave blank)
command.
change circuit pack
Managing MultiMedia Calling
Multimedia Call Handling
Page 1 of 5
275