Avaya Communication Manager Administrator's Manual page 269

•
DS1 Circuit Pack (ESM Only)
— Bit Rate=2.048
— Line Coding=hdb3
— Signaling Mode=isdn-pri
— Connect=pbx
— Interface=network
— Country Protocol=1
— CRC=y
— MMI Cabling Board
•
Signaling group (ESM Only)
— Primary D-Channel
Administration commands
System-Parameters Customer-Options screen
To enable the
MMCH
System-Parameters Features screen
The default bandwidth for MMCH calls is defined on the System-Parameters Features screen shown
below.
NOTE:
Originating a multimedia call with the mm-call button will originate a call according to
the Default Multimedia Parameters selected on the System Parameters Features screen.
•
This default parameter will be either 2x56 or 2x64.
•
The bearer capability of the multimedia calls will either be 56K or 64K and the bandwidth
will be 2B channels.
Data module screen
The H.320 DVC system should contain a BRI interface. You must connect this BRI interface to a port on
a TN556 BRI circuit pack and administer it as a BRI data module.
•
You may administer the data endpoint type as 7500 (recommended) or WCBRI.
•
The fields for multimedia are the same on either screen.
•
The administration for a Basic mode and an Enhanced mode data module are exactly the same.
Administrator's Guide for Avaya Communication Manager
November 2003
feature, you need to purchase a new license file.
Managing MultiMedia Calling
Multimedia Call Handling
269