Avaya Communication Manager Administrator's Manual page 106

Managing Phones
Setting up Remote Office
Setting up a trunk group
You can modify an existing trunk group or add a new one. In our example, we'll add trunk group 6.
Before you start
Perform Setting up a signaling group
To set up the trunk group for your remote office:
1
Type add trunk group 6.
The Trunk Group screen appears.
add trunk-group next
Group Number: 6___
Group Name: ___________________________ COR: __
Direction: ________
Dial Access? _
Queue Length: ___
Service Type: _____
TRUNK PARAMETERS
Trunk Type (in/out): ____________
Outgoing Dial Type: _________
Digit Treatment: __________
Analog Loss Group: ___
Incoming Dial Tone? _
Incoming Calling Number - Delete: ___ Insert: _______ Format: _______
Disconnect Supervision - In? _
Answer Supervision Timeout: ___
2
In the Group Type
ISDN-PRI
3
In the
TAC
4
In the Carrier Medium
5
In the
Dial Access
6
In the
Service Type
7
In the
Signaling Group
8
Press
ENTER
Setting up a signaling group
Each Remote Office has own listen port and signaling group. Set up a new trunk group, or use an existing
trunk group administered for H.323 signaling.
106
on page 106.
Outgoing Display? _
Busy Threshold: ___
BCC: _
Bit Rate: _____
field, type ISDN.
or ISDN-BRI must be y on the System Parameters Customer Options screen.
field, type in the trunk access code that conforms to your dial plan.
field, type IP (Medpro).
field, type y.
field, type tie.
field, type in the signaling group you created.
to save your changes.
Administrator's Guide for Avaya Communication Manager
TRUNK GROUP
Group Type: ________
Trunk Signaling Type: ____
Incoming Destination: ________
Auth Code? _
Trunk Flash? _
ITC? ____
Incoming Rotary Timeout(sec): __
Incoming Dial Type: ________
Disconnect Timing(msec): ____
Sig Bit Inversion: none
Digital Loss Group: ___
Synchronization: _____
Out? _
Receive Answer Supervision? _
Page 1 of x
CDR Reports: _
TN: ___ TAC: __6__
Night Service: ________
Digits: ____
Duplex: ____
November 2003