Avaya Communication Manager Administrator's Manual page 274

Managing MultiMedia Calling
Multimedia Call Handling
Originating a multimedia call with the mm-multinbr button will originate a call according to the
Default Multimedia Parameters selected on the System Parameters Features screen. This default
parameter will be either 2x56 or 2x64. The bearer capability of the multimedia calls will either be
56K or 64K and the bandwidth will be 2B channels.
ESM T.120 Server Administration
Figure 37: DS1 screen (Page 1 of 1)
change ds1 1c09
Signaling Mode: isdn-pri
MMI Cabling Board: 01C10
Slip Detection? n
From the system administration terminal:
1
Enter list configuration all, and a list of the installed carriers, circuit packs, and ports appears.
2
Record the location (board number) of the MMI board cabled to the TN2207 slot and verify that
all other required circuit packs are present.
3
Enter add DS1 xxxxx, (where xxxxx is the location of the TN2207 PRI circuit pack recorded in
step 2), and the DS1 circuit pack administration screen appears.
4
Set the
Name
5
Set the
Bit Rate
The TN2207 DS1 must have a bit rate of 2.048, even if all other DS1 boards in the system are
operating at 1.544. Verify the 24/32 channel switch on the circuit pack is in the 32 channel
position.
6
Set the
Line Coding
7
Set the
Signaling Mode
8
Set the
Connect
9
Set the
Interface
10
Set the Country Protocol
11
Set the
CRC
12
The Idle Code
13
The DCP/Analog Bearer Capability
274
DS1 CIRCUIT PACK
Location: 01C09
Bit Rate: 2.048
Connect: pbx
Idle Code: 11111111
DCP/Analog Bearer Capability: 3.1kHz
field to ESM DS1.
field to 2.048.
field to hdb3.
field to isdn-pri.
field to pbx.
field to network
field to 1.
field to y
default is 11111111.
Administrator's Guide for Avaya Communication Manager
Name:
Line Coding: hdb3
Interface: network
Country Protocol: 1
CRC? y
MMI Interface: ESM
Near-end CSU Type: other
default is 3.1 kHz.
Page 1 of 1
November 2003