Avaya Communication Manager Administrator's Manual page 361

Instructions
The following example shows a DS1 circuit pack configured for T1 service. The circuit pack is
supporting a two-way CO trunk group that carries only voice and voice-grade data.
To configure a new DS1 circuit pack:
1
Type add ds1 07A19 and press
The DS1 Circuit Pack screen appears. You must enter a specific port address for the circuit pack.
Line Compensation: 1
Interface Companding: mulaw
2
Type two-way CO in the
Use this name to record useful information such as the type of trunk group associated with this
circuit pack or its destination.
3
In the
Bit Rate
This is the standard for T1 lines.
4
In the Line Coding
Avaya recommends you use b8zs whenever your service provider supports it. Since this trunk
group only carries voice traffic, you could also use ami-zcs without a problem.
5
In the
Framing Mode
Avaya recommends you use esf whenever your service provider supports it.
6
In the Signaling Mode
7
In the Interface Companding
This is the standard for T1 lines in North America.
8
Press
ENTER
Administrator's Guide for Avaya Communication Manager
November 2003
ENTER
Location: 07A19
Bit Rate: 1.544
Signaling Mode: robbed-bit
Idle Code: 11111111
Slip Detection? y
field.
Name
field, type 1.544.
field, type b8zs.
field, type esf.
field, type robbed-bit.
field, type mulaw.
to save your changes.
.
DS1 CIRCUIT PACK
Line Coding: b8zs
Framing Mode: esf
Managing Trunks
Setting up digital trunks
Name: two-way CO
361