Avaya Communication Manager Administrator's Manual page 363

If you busy out the DS1 circuit pack, you can change the following fields: CRC, Connect, Country
Protocol, Framing Mode, Interface, Interconnect, Line Coding, and Protocol Version. After changing
these fields, you may also have to change and resubmit associated screens.
Matching field settings on different screens
For enhanced DS1 administration, some field values on the DS1 Circuit Pack screen must be consistent
with those on other screens as shown in the table below. If you change field values on the DS1 screen,
you must change the related fields on the other screens and resubmit them.
DS1 Circuit Pack field
Line Coding
Connect
Protocol Version
Interface
Interconnect
Country Protocol
Specific combinations of settings for some of these fields are shown below.
ITC, Bit Rate, and Line Coding
The
ITC (Information Transfer Capability)
screen, and Access Endpoint screen. The
Pack screen. The settings for these fields on all the screens must be coordinated as shown in the
following tables.
ITC field
restricted
unrestricted
Administrator's Guide for Avaya Communication Manager
November 2003
Affected screens
Route Pattern
Access Endpoint
PRI Endpoint
Signaling Group
Tone Generation
Signaling Group
Signaling Group
Signaling Group
Tone Generation
Signaling Group
Tone Generation
field appears on the Route Pattern screen, Trunk Group
and the
Line Coding
Bit Rate
1.544 Mbps
2.048 Mbps
1.544 Mbps
2.048 Mbps
Managing Trunks
Setting up digital trunks
fields appear on the DS1 Circuit
Bit Rate
Line Coding field
ami-zcs
ami-basic
b8zs
hdb3
363