Restoring Announcements - Avaya Communication Manager Administrator's Manual

Managing Announcements

Restoring Announcements

Restoring Announcements
NOTE:
This task only applies if you are using a TN750-series announcement circuit pack.
If you are using the TN2501AP (VAL) announcement circuit pack or VVAL
announcements, see
device
If you are using the ISSPA announcements capability of the S8100 Media Server, see
Backup and restore main menu (S8100 Media Server only)
You can restore announcements from system memory to an announcement circuit pack. Your system
memory is a tape, disk, or memory card, depending on your system.
If you have a duplicated system, you system always restores the announcements located on the active
processor.
Instructions
We will restore announcements from our system memory (stored on a disk) to the integrated
announcement circuit pack on our system.
To restore announcements from system memory to the integrated announcement circuit pack:
1
Type restore announcements disk
We will restore announcements from system memory to an announcement circuit pack that has built-in
memory. We know that the announcement circuit pack is located at 01B18:
1
Type
restore announcements from cabinet 01. carrier B, slot 18
2
Press
ENTER
Fixing problems
Problem
You receive
error code
E28
You receive
error code
E31
If the system crashes or there is a processor interchange during restore announcements, the restore fails
and there is no valid announcement on the circuit pack. Repeat the process when the system is operating
properly.
380
Moving announcements to a VAL circuit pack or to another LAN
on page 392.
and press
to restore announcements.
Possible causes and solutions
You do not have an integrated announcement circuit pack in the system.
A call is connected to the announcement on the circuit pack and the port is busy.
Wait for the call to disconnect and try restore announcements again.
Administrator's Guide for Avaya Communication Manager
on page 53.
.
ENTER
and press .
ENTER
November 2003