Managing Phones; Installing New Phones - Avaya Communication Manager Administrator's Manual

3

Managing Phones

Installing New Phones

Simple administration allows you to plug a telephone into a jack and dial a sequence to start up service to
the phone. The dialing sequence sets up an association between the phone and the corresponding station
administration.
!
SECURITY ALERT:
If you do not manage this feature carefully, its unauthorized use may cause you security
problems. Consult the Avaya Products Security Handbook for suggestions on how to
secure your system and find out about obtaining additional security information.
For traditional instructions, see
Before you start
On the Feature-Related System Parameters
Enabled field is y and the
Complete the Station screen for the new phone and type x in the port field. Note that the phone type must
match the board type. For example, match a two-wire digital phone with a port on a two-wire digital
circuit pack. Use this procedure with all circuit-switched phones except BRI (ISDN) and model 7103A.
Tip:
See
Phones
Instructions
CAUTION:
You can destroy your hardware if you attempt to connect an analog telephone to a digital
port.
To associate a phone with existing x-port station administration, complete the following steps from the
telephone you want to install:
1
Plug the phone into the wall jack.
2
Lift the receiver and continue if you hear dial tone.
3
Dial #*nnnn, where
4
Hang up after you receive confirmation tone.
Administrator's Guide for Avaya Communication Manager
November 2003
Installing New
screen, be sure the
TTI Enabled field is y.
Completing the station screens
if you want to add a number of phones with similar settings.
nnnn is the extension number of the phone you are installing.
Phones.
Customer Telephone Activation (CTA)
for more information. See
Managing Phones
Installing New Phones
Using Templates to Add
81