Copying Announcements - Avaya Communication Manager Administrator's Manual

If you have a duplicated system with an active processor and a stand-by processor, you can save
announcements from the announcement circuit pack to both processors. Simply add system memory for
both processors to the save announcements command.
If the save announcements procedure fails on one of the processors, it continues on the other processor,
which results in inconsistent announcement data between the two processors.
To verify that the save announcements command was successful:
1
Type display integrated announcement boards and press
The Integrated Announcement Boards screen appears.
This screen shows the date, time, and location of the announcement circuit pack most recently saved. If
the save announcement command failed or the save translations were not run before rebooting, "N/A"
appears in these fields.

Copying Announcements

NOTE:
This task only applies if you are using a TN750-series announcement circuit pack.
If you are using the TN2501AP (VAL) announcement circuit pack or VVAL
announcements, see
If you are using the ISSPA announcements capability of the S8100 Media Server, see
Backup via the Web interface (S8100 Media Server only)
You can copy recorded announcements between back-up disks and tapes when you want to store your
recorded announcements in more than one place.
Instructions
We will copy the announcements stored in our weekly disk back-up to the tape back-up we take off
company premises for a month. To copy announcements between your back-up disk and tape:
1
Type copy announcements and press
This process can take up to 40 minutes. You cannot administer your system while it is copying
announcements.
Administrator's Guide for Avaya Communication Manager
November 2003
Moving announcements from the VAL circuit pack
to save the changes.
ENTER
Managing Announcements
Copying Announcements
.
ENTER
on page 391.
on page 52.
379