Siemens G130 List Manual page 1068

2 Parameters
2.2 List of parameters
p60122 IF1 PROFIdrive SIC/SCC telegram selection / IF1 SIC/SCC telegr
VECTOR_G Can be changed: T
Data type: Integer16
P-Group: Communications
Not for motor type: -
Min
700
Description: Sets the telegram for the safety information channel (SIC) / safety control channel (SCC).
The SIC/SCC telegram p60122 is attached directly to the PZD telegram p0922/p2079.
Value: 700:
701:
999:
Note: The clearance to the PZD telegram can be increased using p2070/p2071.
After changing p0922/p2079 or p2070/p2071, then p60122 must be set again.
The telegram interconnections can only be changed if p60122 and p0922 are both set to 999.
r61000[0...239] PROFINET Name of Station / PN Name of Station
CU_G130_PN, Can be changed: -
CU_G150_PN,
Data type: Unsigned8
CU_G130_DP (PN
P-Group: -
CBE20),
Not for motor type: -
CU_G150_DP (PN
CBE20)
Min
-
Description: Displays PROFINET Name of Station.
Notice: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
r61001[0...3] PROFINET IP of Station / PN IP of Station
CU_G130_PN, Can be changed: -
CU_G150_PN,
Data type: Unsigned8
CU_G130_DP (PN
P-Group: -
CBE20),
Not for motor type: -
CU_G150_DP (PN
CBE20)
Min
-
Description: Displays PROFINET IP of Station.
1068
Supplementary telegram 700, PZD-0/3
Supplementary telegram 701, PZD-2/5
Free telegram configuration with BICO
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
999
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
Calculated: -
Dyn. index: -
Unit group: -
Scaling: -
Max
-
List Manual (LH2), 07/2016, A5E03263479A
Access level: 3
Func. diagram: 2423
Unit selection: -
Expert list: 1
Factory setting
999
Access level: 3
Func. diagram: 2410
Unit selection: -
Expert list: 1
Factory setting
-
Access level: 3
Func. diagram: 2410
Unit selection: -
Expert list: 1
Factory setting
-
SINAMICS G130/G150