Tunnel-Assignment-Id - Juniper JUNOSE SOFTWARE 11.0.X - BROADBAND ACCESS CONFIGURATION GUIDE 4-1-2010 Configuration Manual

radius include connect-info
Related Topics

[82] Tunnel-Assignment-Id

Use the following command to manage the Tunnel-Assignment-Id RADIUS attribute.
radius include tunnel-assignment-id
tx-speed [ /rx-speed ]
The TX speed is always included in the attribute when the speed is not zero;
however, inclusion of the RX speed depends on the keyword you use with the
command.
Use the l2tp-connect-speed keyword to specify that the RX speed is only
included when it is not zero and differs from the TX speed.
Example
host1(config)#radius connect-info-format l2tp-connect-speed
Use the l2tp-connect-speed-rx-when-equal keyword to specify that the RX
speed is always included when it is not zero.
Example
host1(config)#radius connect-info-format l2tp-connect-speed-rx-when-equal
Use the no version to disable the inclusion of the RX speed when it is the same
as the TX speed.
See radius connect-info-format
Use to include the Connect-Info attribute in Access-Request, Acct-Start, or
Acct-Stop messages.
You can control inclusion of the Connect-Info attribute by enabling or disabling
this command.
See radius include
Example
host1(config)#radius include connect-info access-request disable
Use the no version to restore the default, enable.
Monitoring the Connect-Info RADIUS Attribute on page 301
radius include tunnel-assignment-id
Use to include the Tunnel-Assignment-Id attribute in Acct-Start or Acct-Stop
messages.
Chapter 3: Configuring RADIUS Attributes
CLI Commands Used to Modify RADIUS Attributes
207