Address Send Version - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

address send version

address { ipAddress | unnumbered interfaceType interfaceSpecifier }
Syntax
send version { 1 | 2 | 1 2 | 2 1 | off }
no address [ ipAddress | unnumbered interfaceType interfaceSpecifier ] send version
Command introduced before JUNOSe Release 7.1.0.
Release Information
Restricts the RIP version that the router can send on an interface. The no version
Description
sets the interface back to the default value, sending only RIP version 1.
Options
Address Family Configuration, Router Configuration
Mode
ipAddress Address of IP interface where RIP will be run
unnumbered Specifies that RIP will be run on an unnumbered interface
interfaceType Interface type; see "Interface Types and Specifiers" on page 5
interfaceSpecifier—Particular interface; format varies according to interface
type; see Interface Types and Specifiers on page 5
1 Specifies RIP version 1 only
2 Specifies RIP version 2 only
1 2 Specifies RIP version 1 and version 2
2 1 Specifies RIP version 2 and version 1
off Turns reception off
Chapter 2: A Commands
105
address send version