Address Area - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

address area

[ no ] address { ipAddress | unnumbered interfaceType interfaceSpecifier }
Syntax
area { areaId | areaIdInt }
Command introduced before JUNOSe Release 7.1.0.
Release Information
Creates an interface on which OSPF runs in the specified area, on top of the IP
Description
interface at the specified IP address. Uses the default values. The no version deletes
OSPF interfaces. If the OSPF network was previously specified with the network
area command, the OSPF interface already exists, and you do not need to use this
command, unless you want to change the area of the OSPF interface to an area
different from the one specified by the network area command.
NOTE: Before you issue this command, you must first configure an interface with
the IP address specified by ipAddress or an interface configured as unnumbered.
You must issue this command before issuing any other OSPF address command.
Options
Router Configuration
Mode
86
address area
ipAddress IP address of the interface on which OSPF will be run
unnumbered Configures OSPF on an unnumbered interface
interfaceType Interface type; see "Interface Types and Specifiers" on
page 5
interfaceSpecifier—Particular interface; format varies according to interface
type; see Interface Types and Specifiers on page 5
areaId OSPF area ID in IP address format
areaIdInt OSPF area ID as a decimal value in the range 1–4294967295