Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 157

Table 8: Statements for Physical Interface Properties (continued)
Statement
lmi lmi-options
lmi
lmi-type (ansi | itu)
local-name name
lockout
log-prefix prefix-number
(long-buildout | no-long-buildout)
(loop-timing | no-loop-timing)
loopback mode
loopback mode
loopback mode
(loopback | no-loopback)
loss-priority (high | low)
lowest-priority-defect (all-defects |
err-xcon | mac-rem-err-xcon |
no-defect | rem-err-xcon | xcon)
low-plp-max-threshold percent
Interface Types
Interfaces with Frame Relay encapsulation
OAM CFM Ethernet Local Management
Interface
Link services interfaces and interfaces with
Frame Relay encapsulation
Interfaces with PPP encapsulation
SONET/SDH interfaces
Adaptive services interfaces
T3 interfaces
Channelized IQ interfaces
DS0, E1, E3, T1, T3, SHDSL on ATM and
ATM interfaces on J Series routers, and
SONET/SDH interfaces
Ethernet and 10-Gigabit Ethernet
interfaces in WAN PHY mode
Serial interfaces
Aggregated Ethernet, Fast Ethernet, and
Gigabit Ethernet interfaces
Gigabit Ethernet IQ interfaces
Configuring IEEE 802.1ag OAM
connectivity-fault management
ATM2 interfaces
Chapter 3: Configuring Physical Interface Properties
Usage Guidelines
"Configuring Tunable Keepalives for
Frame Relay LMI" on page 386 and JUNOS
Services Interfaces Configuration Guide
"Configuring Ethernet Local Management
Interface" on page 715
"Configuring Frame Relay Keepalives" on
page 385
"Configuring the PPP Challenge
Handshake Authentication Protocol" on
page 124
"Configuring APS and MSP" on page 911
JUNOS Services Interfaces Configuration
Guide
"Configuring the T3 Line Buildout" on
page 593
"Configuring the Channelized T3 Loop
Timing" on page 594
"Configuring E1 Loopback Capability" on
page 564, "Configuring E3 Loopback
Capability" on page 573, "Configuring T1
Loopback Capability" on page 583,
"Configuring T3 Loopback Capability" on
page 594, "Configuring SHDSL Operating
Mode on an ATM Physical Interface" on
page 372, and "Configuring SONET Options
for 10-Gigabit Ethernet Interfaces" on
page 927
"Configuring Ethernet Loopback
Capability" on page 612
"Configuring Serial Loopback Capability"
on page 281
"Configuring Ethernet Loopback
Capability" on page 612
"Specifying an Output Priority Map" on
page 789
"Configuring a Maintenance Endpoint" on
page 709
"Configuring ATM2 IQ VC Tunnel CoS
Components" on page 347
Physical Interfaces Properties Statements List
87