Configuring The Local Name; Configuring The Local Password - Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual

JUNOS 10.1 Network Interfaces Configuration Guide
To configure PPP PAP on a logical interface with PPP encapsulation, include the
statement with options:
You can include these statements at the following hierarchy levels:
For more information about configuring PAP for logical interfaces, see "Configuring
PPP PAP Authentication" on page 175. For information about configuring tracing
operations for PPP, see "Tracing Operations of the pppd Process" on page 131.
On each physical interface with PPP encapsulation, you can perform one of the
following tasks:

Configuring the Local Name

By default, when PAP is enabled on an interface, the interface uses the router s
system hostname as the name sent in PAP request and response packets.
To configure the name the interface uses in PAP request and response packets,
include the
pap]

Configuring the Local Password

You need to configure the password to be used for authentication. To configure the
host password for sending PAP requests, include the
[edit interfaces interface-name ppp-options pap]
128
Configuring the PPP Password Authentication Protocol
}
pap {
default-pap-password password;
local-name name;
local-password password;
passive;
}
[edit interfaces interface-name unit logical-unit-number]
[edit logical-systems logical-system-name interfaces interface-name unit
logical-unit-number]
Configuring the Local Name on page 128
Configuring the Local Password on page 128
Configuring Passive Mode on page 129
Example: Configuring PAP Authentication Protocol on page 129
statement at the
local-name
hierarchy level:
[edit interfaces interface-name ppp-options pap]
local-name name;
[edit interfaces interface-name ppp-options pap]
local-password password;
[edit interfaces interface-name ppp-options
local-password
hierarchy level:
pap
statement at the