Control Plane Configuration Mode; Controller Configuration Mode - Juniper SYSTEM BASICS - CONFIGURATION GUIDE V 11.1.X Configuration Manual

JUNOSe 11.1.x System Basics Configuration Guide
From Rate Limit Profile Configuration mode, type the color-mark-profile command
and specify a profileName, and then press Enter.
host1(config-rate-limit-profile)# mpls
host1(config-color-mark-profile)#?

Control Plane Configuration Mode

In this mode, you can configure policing for a specific protocol.
From Global Configuration mode, type the control-plane command and press Enter.
host1(config)#control-plane
host1(config-control-plane)#?

Controller Configuration Mode

You can configure physical interfaces such as a T3 in Controller Configuration mode.
From Global Configuration mode, type the appropriate controller command and its
attributes, and then press Enter.
host1(config)#controller t3 9/1
host1(config-controll)#
host1(config)#controller ?
92
Accessing Command Modes
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
green-mark Apply TOS mark to IP packets classified Green by the rate limit
hierarchy
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
mask-value Mask for all TOS values applied by the color-mark profile
no Negate a command or set its default(s)
red-mark Apply TOS mark to IP packets classified Red by the rate limit
hierarchy
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
yellow-mark Apply TOS mark to IP packets classified Yellow by the rate limit
hierarchy
default Set a command to its default(s)
do Run an exec mode command (alias command run)
exit Exit from the current command mode
help Describe the interactive help system
log Configure logging settings
macro Run a CLI macro
no Negate a command or set its default(s)
policer Configure policing
run Run an exec mode command (alias command do)
sleep Make the Command Interface pause for a specified duration
e1 Configure a channelized E1 controller
e3 Configure a E3 controller
sonet Configure a Sonet controller
t1 Configure a channelized T1 controller
t3 Configure a T3 controller
color-mark-profile myprofile