Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 146

JUNOS 10.1 Network Interfaces Configuration Guide
76
Physical Interface Configuration Statements Overview
}
compression {
acfc;
pfc;
}
dynamic-profile profile-name;
no-termination-request;
pap {
access-profile name;
local-name name;
local-password password;
passive;
}
}
receive-bucket {
overflow (discard | tag);
rate percentage;
threshold bytes;
}
redundancy-options {
primary sp-fpc/pic/port;
secondary sp-fpc/pic/port;
}
schedulers number;
serial-options {
clock-rate rate;
clocking-mode (dce | internal | loop);
control-polarity (negative | positive);
cts-polarity (negative | positive);
dcd-polarity (negative | positive);
dce-options {
control-signal (assert | de-assert | normal);
cts (ignore | normal | require);
dcd (ignore | normal | require);
dsr (ignore | normal | require);
dtr signal-handling-option;
ignore-all;
indication (ignore | normal | require);
rts (assert | de-assert | normal);
tm (ignore | normal | require);
}
dsr-polarity (negative | positive);
dte-options {
control-signal (assert | de-assert | normal);
cts (ignore | normal | require);
dcd (ignore | normal | require);
dsr (ignore | normal | require);
dtr signal-handling-option;
ignore-all;
indication (ignore | normal | require);
rts (assert | de-assert | normal);
tm (ignore | normal | require);
}
dtr-circuit (balanced | unbalanced);
dtr-polarity (negative | positive);
encoding (nrz | nrzi);