Configuring A Saml Access Control Resource Policy (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING SECURE ACCESS DEVICES GUIDE REV 01 Manual

Table 60: Basic Authentication, NTLM, or Kerberos Intermediation Policy (continued)
Options
Detailed Rules tab
Detailed Rule
Conditions
Related
Documentation

Configuring a SAML Access Control Resource Policy (NSM Procedure)

Copyright © 2010, Juniper Networks, Inc.
Your Action
Enter the detailed rule information as described in the General tab section of Table 60 on
page 222.
Click New Expression and enter a condition name for the rule. You can also set conditions
for the rule. Conditions include logical operators, prebuilt expressions, variables, and so
on.
Configuring a SAML Access Control Resource Policy (NSM Procedure) on page 223
Configuring SAML SSO Artifact Profile Resource Policy (NSM Procedure) on page 226
Configuring Basic, NTLM, and Kerberos Resources (NSM Procedure) on page 218
When enabling access control transactions to a trusted access management system,
the Secure Access device and trusted access management system exchanges information.
To configure a SAML access control resource policy:
In the navigation tree, select Device Manager > Devices. Click the Device Tree tab,
1.
and then double-click the Secure Access device for which you want to configure a
SAML access control resource policy.
Click the Configuration tab. Select Users > Resource Policies > Web > SAML ACL.
2.
Add or modify settings as specified in Table 61 on page 223.
3.
Click one:
4.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 61: Configuring SAML Access Control Resource Policy Details
SAML ACL > General tab or Detailed Rule tab
Name Specifies the name of the policy.
Description Describes the policy.
New Resources Specifies the resources to which this
policy applies.
Chapter 14: Configuring Single Sign-On
Enter the name.
Enter the policy.
Enter the resources.
223