Juniper JUNOS 10.1 - CONFIGURATION GUIDE 1-2010 Configuration Manual page 150

JUNOS 10.1 Network Interfaces Configuration Guide
Table 8: Statements for Physical Interface Properties (continued)
Statement
action-red-differential-delay
(disable-tx | remove-link)
advertise-interval milliseconds
aggregate
aggregate asx
aggregated-ether-options
aggregate-ports
aggregated-sonet-options
alarmalarm-name
(syslog | link-down)
annex (annex-a | annex-b)
aps
atm-encapsulation (direct | plcp)
atm-options
authentication-key key
backup-interface
bandwidth-limit bps
80
Physical Interfaces Properties Statements List
Interface Types
Link services and voice services interfaces
SONET/SDH interfaces
Gigabit Ethernet intelligent queuing (IQ
and IQE) interfaces and Gigabit Ethernet
interfaces with small form-factor pluggable
transceivers (SFPs) (except the 10-port
Gigabit Ethernet PIC and the built-in
Gigabit Ethernet port on the M7i router)
Aggregated SONET/SDH interfaces
Aggregated Ethernet interfaces
SONET/SDH interfaces
Aggregated SONET/SDH interfaces
10-Gigabit Ethernet interfaces
ATM interfaces on J Series routers
SONET interfaces using annex-b for MSP
switching on M320 and M120 Routers
SONET/SDH interfaces
E3 and T3 traffic over Asynchronous
Transfer Mode (ATM) interfaces
ATM1 and ATM2 IQ interfaces
SONET/SDH interfaces
E1, E3, T1, T3 and Fast Ethernet
Gigabit Ethernet and Gigabit Ethernet IQ
and IQE PICs with SFPs (except the
10-port Gigabit Ethernet PIC and the
built-in Gigabit Ethernet port on the M7i
router)
Usage Guidelines
JUNOS Services Interfaces Configuration
Guide
"Configuring APS and MSP" on page 911
"Configuring Gigabit Ethernet Policers" on
page 787
"Configuring Aggregated SONET/SDH
Interfaces" on page 936
"Aggregated Ethernet Interfaces
Overview" on page 643
"Specifying OC768-over-OC192 Mode" on
page 107
"Configuring Aggregated SONET/SDH
Interfaces" on page 936
"Configuring 10-Gigabit Ethernet Link
Down Notification for Optics Options
Alarm or Warning" on page 821
"Configuring SHDSL Operating Mode on
an ATM Physical Interface" on page 372
"Configuring APS and MSP" on page 911
"Configuring APS and MSP" on page 911
"Configuring E3 and T3 Parameters on
ATM Interfaces" on page 345
"Interface Encapsulations Overview" on
page 40
"Configuring APS and MSP" on page 911
"Configuring an ISDN Dialer Interface as
a Backup Interface" on page 878
"Configuring Gigabit Ethernet Policers" on
page 787