Qos Trust (Interface) - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
When the system is configured as trust DSCP, traffic is mapped to a queue
according to the DSCP-queue map.
If QoS Mode is set to Advanced, the command
packets that egress from the GE ports.
Example
The following example configures the system to the DSCP trust state.
Console(config)# qos trust
Related Commands
qos cos

qos trust (Interface)

The qos trust (Interface) command enables each port trust state while the system is
in basic mode. Use no for to disable trust state on each port.
qos trust
no qos trust
Default Setting
Each port is enabled while system is in basic mode.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
No Command Usage for this command.
Example.
The following example enables each port trust state while the system is in basic
mode
Console(config)#
Console(config-if) qos trust 3
qos cos
The Interface Configuration (Ethernet, port-channel) mode command
qos cos
defines the default CoS value of a port. To return to the default configuration, use the
form of this command.
no
Syntax
default-cos
qos cos
Parameters
• default-cos — Specifies the default CoS value of the port. (Range: 0 - 7)
Default Setting
Default CoS value of a port is 0.
490
dscp
interface ethernet
is applied only to
qos trust
1/e15