Rate-Limit (Vlan); Show Policy-Map - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
Command Usage
The command can be enabled on a specific port only if port storm-control
brodcast enable interface configuration command is not enabled on that port.
Example
The following example limits the rate of the incoming traffic to 62.
Console(config-ip)# rate-limit 62

rate-limit (VLAN)

The rate-limit VLAN global configuration command limits the rate of the incoming
traffic for a VLAN. Use the no form to disable rate limit.
Syntax
rate-limit vlan committed-rate-kbps committed-burst-byte
no rate-limit vlan
Parameters
• vlan — Specifies the VLAN ID.
• committed-rate-kbps — The average traffic rate (CIR) in kbits per
second(bps).
• committed-burst-byte — The maximum burst size (CBS) in bytes.
Default Setting
Disabled.
Command Mode
Global configuration
Command Usage
Rate limit is calculated separately for each unit in a stack, and for each packet
processor in a unit. Traffic policing in a policy map have precedence over
VLAN rate limiting. I.e. if a packet is subject to traffic policing in a policy map
and is associated with a VLAN that is rate limited, the packet would be
counted only in the traffic policing of the policy map.
Example
The following example limits the rate of the incoming traffic for a VLAN.
Console(config)# rate-limit CIR CBS

show policy-map

The
show policy-map
Syntax
show policy-map
474
User EXEC command displays the policy maps.
[policy-map-name [ class-name]]
class