Alcatel OmniStack LS 6248 User Manual page 368

4
Command Line Interface
LLDP MED - Network Policy
Application type
Flags
VLAN ID
Layer 2 priority
DSCP
LLDP MED - Power Over Ethernet
Power type
Power Source
Power priority
Power value
LLDP MED - Location
Coordinates, Civic address, ECS ELIN.
344
Indicates the primary function of the application
defined for this network policy.
Unknown policy: Policy is required by the device, but
is currently unknown. Tagged VLAN: whether the
specified application type is using a 'tagged' or an
'untagged' VLAN.
VLAN identifier for the application.
Layer 2 priority to be used for the specified
application.
DSCP value to be used for the specified application.
Indicates whether the device is a Power Sourcing
Entity (PSE) or Power Device (PD).
Indicates the power source being utilized by a PSE
or PD device. A PSE device would advertise its
power capability. Available values are: Primary
power source and Backup power source. A PD
device would advertise its power source. Available
values are: Primary power, Local power, Primary
and Local power.
Power priorityIndicates the priority of the PD device.
A PSE device would advertise the power priority
configured for the port. A PD device would advertise
the power priority configured for the device.
Available values are: Critical, High and Low.
Indicates the priority of the PD device. A PSE device
would advertise the power priority configured for the
port. A PD device would advertise the power priority
configured for the device. Available values are:
Critical, High and Low.
Indicates the total power in watts required by a PD
device from a PSE device, or the total power a PSE
device is capable of sourcing over a maximum
length cable based on its current configuration.
Displays the raw data of the location information.