Permit (Ip) - Alcatel OmniStack LS 6248 User Manual

Examples
The following example shows how to create an IP ACL.
Console(config)#
Console(config-ip-al)#
Related Commands

permit (ip)

deny (IP)
show access-lists
service-acl
match
permit (ip)
The IP-Access List Configuration mode command permits traffic if the
permit
conditions defined in the permit statement match.
Syntax
{ | protocol} {
permit any
destination-wildcard}} [
{
permit-icmp any
destination-wildcard}} {
ip-precedence
{
permit-igmp any
destination-wildcard}} {
{
permit-tcp any
destination destination-wildcard}} {
ip-precedence
{
permit-udp any
{destination destination-wildcard}} {
ip-precedence
Parameters
• source — Specifies the source IP address of the packet. Specify
indicate IP address 0.0.0.0 and mask 255.255.255.255.
• source-wildcard — Specifies wildcard to be applied to the source IP
address. Use 1s in bit positions to be ignored. Specify
address 0.0.0.0 and mask 255.255.255.255.
• destination — Specifies the destination IP address of the packet. Specify
to indicate IP address 0.0.0.0 and mask 255.255.255.255.
any
• destination-wildcard — Specifies wildcard to be applied to the destination
IP address. Use 1s in bit positions to be ignored. . Specify
IP address 0.0.0.0 and mask 255.255.255.255.
ip-access-list
| {source source-wildcard}} {
any
dscp number |
dscp
| {source source-wildcard}} {
| icmp-type} {
any
number]
| {source source-wildcard}} {
| igmp-type} [
any
| { source source-wildcard}} {
number] [ list-of-flags]
flags
| { source source-wildcard}} {
number]
ip-acl1
ip-precedence
| {destination
any
| icmp-code} [
any
| {destination
any
number |
dscp
| source-port} {
any
any | destination-port} [
| source-port} {
any
| destination-port} [
any
ACL Commands
| {destination
any
ip-precedence]
number |
dscp
number]
ip-precedence
|{
any
dscp number |
|
any
number |
dscp
any to
to indicate IP
any
any to indicate
4
301