Traffic-Shape - Alcatel OmniStack LS 6248 User Manual

Command Usage
Configuring the number of expedite queues affects the Weighted Round Robin
(WRR) weight ratio because fewer queues participate in the WRR.
Example
The following example configures the number of expedite queues as 0.
Console(config)#
Related Commands
wrr-queue cos-map

traffic-shape

The Interface Configuration (Ethernet, port-channel) mode command
traffic-shape
configures the shaper of the egress port. To disable the shaper, use the
this command.
Syntax
{ committed-rate committed-burst }
traffic-shape
no traffic-shape
Parameters
• committed-rate — Specifies the average traffic rate (CIR) in Kbps.
(Range: 64-1000000)
• excess-burst — Specifies the excess burst size (CBS) in bytes.
(Range: 4096-16769020). The FE maximum rate is 62500.
Default Setting
No shape is defined.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
Command Usage
This command activates the shaper on a specified egress port.
To activate the shaper on an egress port, enter the Interface Configuration
mode and specify the port number. Then run this command without the
parameter. The CIR and the CBS will be applied to the specified port.
queue-id
Example
The following example sets a shaper on Ethernet port 1/g1 when the average traffic
rate exceeds 124000 bps or the normal burst size exceeds 96000 bps.
Console(config)#
Console(config-if)
priority-queue out num-of-queues
interface ethernet
traffic-shape
1/g1
124000 96000
4
QoS Commands
0
form of
no
483