Alcatel OmniStack LS 6248 User Manual page 551

Parameters
• ip-address — Specifies the IP address of the host (targeted recipient).
• hostname — Specifies the name of the host. (Range:1-158 characters)
• community-string — Specifies a password-like community string sent with
the notification operation. (Range: 1-20)
• — Indicates that SNMP traps are sent to this host. If unspecified,
traps
SNMPv2 traps are sent to the host.
• — Indicates that SNMP informs are sent to this host. Not applicable
informs
to SNMPv1.
• — Indicates that SNMPv1 traps will be used.
1
• — Indicates that SNMPv2 traps will be used. If
2
• port — Specifies the UDP port of the host to use. If unspecified, the default
UDP port number is 162. (Range:1-65535)
• filtername — Specifies a string that defines the filter for this host. If
unspecified, nothing is filtered. (Range: 1-30 characters)
• seconds — Specifies the number of seconds to wait for an acknowledgment
before resending informs. If unspecified, the default timeout period is 15
seconds. (Range: 1-300)
• retries — Specifies the maximum number of times to resend an inform
request. If unspecified, the default maximum number of retries is 3.
(Range: 1-255)
Default Setting
This command has no default configuration.
Command Mode
Global Configuration mode
Command Usage
When configuring an SNMPv1 or SNMPv2 notification recipient, a notification
view for that recipient is automatically generated for all the MIB.
When configuring an SNMPv1 notification recipient, the
be selected.
If a trap and inform are defined on the same target, and an inform was sent,
the trap is not sent.
Example
The following example enables SNMP traps for host 10.1.1.1 with community string
"management" using SNMPv2.
Console(config)# snmp-server host 10.1.1.1 management 2
Related Commands
show snmp
SNMP Commands
option cannot
Inform
4
527