Ip Igmp Snooping Leave-Time-Out - Alcatel OmniStack LS 6248 User Manual

Syntax
ip igmp snooping mrouter-time-out
no ip igmp snooping mrouter-time-out
Parameters
• time-out — Multicast device timeout in seconds (Range: 1 - 2147483647)
Default Setting
The default value is 300 seconds.
Command Mode
Interface Configuration (VLAN) mode
Command Usage
There are no user guidelines for this command.
Example
The following example configures the multicast device timeout to 200 seconds.
Console(config)#
Console(config-if)#
Related Commands
ip igmp snooping querier enable

ip igmp snooping leave-time-out

The ip igmp snooping leave-time-out
command configures the leave-time-out. If an IGMP report for a multicast group was
not received for a leave-time-out period after an IGMP Leave was received from a
specific port, this port is deleted from the member list of that multicast group. To
return to the default configuration, use the
Syntax
ip igmp snooping leave-time-out
no ip igmp snooping leave-time-out
Parameters
• time-out — Specifies the leave-time-out in seconds for IGMP queries.
(Range: 0-2147483647)
•
immediate-leave
from the members list after receiving IGMP Leave.
Default Setting
The default leave-time-out configuration is 10 seconds.
Command Mode
Interface Configuration (VLAN) mode
interface vlan
ip igmp snooping mrouter-time-out
Interface Configuration (VLAN) mode
{time-out |
— Indicates that the port should be immediately removed
IGMP Snooping Commands
time-out
2
form of this command.
no
immediate-leave
4
200
}
411