Arp Timeout - Alcatel OmniStack LS 6248 User Manual

Command Usage
The software uses ARP cache entries to translate 32-bit IP addresses into
48-bit hardware addresses. Because most hosts support dynamic resolution,
static ARP cache entries do not generally have to be specified.
Example
The following example adds IP address 198.133.219.232 and MAC address
00:00:0c:40:0f:bc to the ARP table.
Console(config)#
Related Commands

arp timeout

show arp
arp timeout
The Global Configuration mode command configures how long an entry
arp timeout
remains in the ARP cache. To return to the default configuration, use the
this command.
Syntax
seconds
arp timeout
no arp timeout
Parameters
• seconds — Time (in seconds) that an entry remains in the ARP cache.
(Range: 1 - 40000000)
Default Setting
The default timeout is 60000 seconds.
Command Mode
Global Configuration mode
Command Usage
It is recommended not to set the timeout value to less than 3600.
Example
The following example configures the ARP timeout to 12000 seconds.
Console(config)#
Related Commands
arp
show arp
arp
198.133.219.232 00:00:0c:40:0f:bc
arp timeout
12000
IP Addressing Commands
ethernet
no
4
1/e6
form of
423