Acl Commands; Ip-Access-List - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface

ACL Commands

.
Command

ip-access-list

permit (ip)
deny (IP)
mac access-list
permit (MAC)
deny (MAC)
service-acl
show access-lists
show interfaces
access-lists
ip-access-list
The
ip-access-list
Configuration mode and creates Layer 3 ACLs. To delete an ACL, use the
this command.
Syntax
ip-access-list
no ip-access-list
Parameters
• name — Specifies the name of the ACL.
Default Setting
The default for all ACLs is
Command Mode
Global Configuration mode
Command Usage
Up to 1018 rules can be defined on the device, depending on the type of rule
defined.
300
Table 4-7. ACL Commands
Function
Enables the IP-Access Configuration mode and creates Layer 3
ACLs. To delete an ACL, use the no form of this command.
Permits traffic if the conditions defined in the permit statement
match.
Denies traffic if the conditions defined in the deny statement
match.
Enables the MAC-Access List Configuration mode and creates
Layer 2 ACLs. To delete an ACL, use the no form of this
command.
Defines permit conditions of an MAC ACL.
Denies traffic if the conditions defined in the deny statement
match.
Applies an ACL to the input interface. To detach an ACL from an
input interface, use the no form of this command.
Displays access control lists (ACLs) defined on the device.
Displays access lists applied on interfaces.
Global Configuration command enables the IP-Access
name
name
deny-all
.
Mode Page
GC 4-300
ACL 4-301
ACL 4-304
GC 4-306
ACL 4-307
ACL 4-308
IC 4-310
PE 4-310
PE 4-311
form of
no