Permit (Mac) - Alcatel OmniStack LS 6248 User Manual

Parameters
• name — Specifies the name of the ACL.
Default Setting
The default for all ACLs is
Command Mode
Global Configuration mode
Command Usage
There are no user guidelines for this command.
Example
The following example shows how to create a MAC ACL.
Console(config)#
Console(config-mac-al)#
Related Commands

permit (MAC)

deny (MAC)
show access-lists
service-acl
match
permit (MAC)
The MAC-Access List Configuration mode command defines permit
permit
conditions of an MAC ACL.
Syntax
{ | {
permit any
destination-wildcard}} [
[inner-vlan vlan-id]
Parameters
• source — Specifies the source MAC address of the packet.
• source-wildcard — Specifies wildcard bits to be applied to the source MAC
address. Use 1s in bit positions to be ignored.
• destination — Specifies the MAC address of the host to which the packet is
being sent.
• destination-wildcard — Specifies wildcard bits to be applied to the
destination MAC address. Use 1s in bit positions to be ignored.
• vlan-id — Specifies the ID of the packet vlan. (Range: 0-4095)
• cos — Specifies the Class of Service (CoS) for the packet. (Range: 0-7)
• cos-wildcard — Specifies wildcard bits to be applied to the CoS.
• eth-type — Specifies the Ethernet type of the packet.(Range: 0-0xFFFF)
deny all
mac access-list
source source-wildcard}
host
vlan-id] [
vlan
.
macl-acl1
| {destination
any
cos cos-wildcard] [
cos
4
ACL Commands
eth-type]
ethtype
307