4
Command Line Interface
Examples
The following example forwards frames with source addresses that are not the
supplicant address and sends consecutive traps at intervals of 100 seconds.
Console(config-if)#
Related Commands
dot1x multiple-hosts
show dot1x advanced
dot1x guest-vlan
The
dot1x guest-vlan
VLAN. To return to the default configuration, use the
Syntax
dot1x guest-vlan
no dot1x guest-vlan
Default Setting
No VLAN is defined as a guest VLAN.
Command Mode
Interface Configuration (VLAN) mode
Command Usage
Use the
dot1x guest-vlan enable
enable unauthorized users on an interface to access the guest VLAN.
If the guest VLAN is defined and enabled, the port automatically joins the
guest VLAN when the port is unauthorized and leaves it when the port
becomes authorized. To be able to join or leave the guest VLAN, the port
should not be a static member of the guest VLAN.
Example
The following example defines VLAN 2 as a guest VLAN.
Console#
configure
Console#
Console(config)#
Console(config-vlan)#
Console(config-vlan)#
Console(config)#
Console(config-if)#
Related Commands
dot1x guest-vlan enable
show dot1x advanced
284
dot1x single-host-violation forward trap
Interface Configuration mode command defines a guest
Interface Configuration mode command to
vlan database
vlan
2
exit
interface vlan
dot1x guest-vlan
form of this command.
no
2
100