Permit (Management) - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
If you reenter an access list context, the new rules are entered at the end of
the access list.
Use the
management access-class
The active management list cannot be updated or removed.
Management ACL requires a valid management interface, which is a port,
VLAN, or port-channnel with an IP address or console interface. Management
ACL only restricts access to the device for management configuration or
viewing.
Example
The following example creates a management access list called mlist, configures
management Ethernet interfaces 1/e1 and 2/e9 and makes the new access list the
active list.
Console(config)#
Console(config-macl)#
Console(config-macl)#
Console(config-macl)#
Console(config)#
The following example creates a management access list called mlist, configures all
interfaces to be management interfaces except Ethernet interfaces 1/e1 and 2/e9
and makes the new access list the active list.
Console(config)#
Console(config-macl)#
Console(config-macl)#
Console(config-macl)#
Console(config-macl)#
Console(config)#
Related Commands

permit (Management)

deny (Management)
show management access-list
show management access-class
management access-class
permit (Management)
The Management Access-List Configuration mode command defines a
permit
permit rule.
Syntax
permit [ ethernet
port-channel-number] [
446
management access-list
permit ethernet
permit ethernet
exit
management access-class
management access-list
deny ethernet
deny ethernet
permit
exit
management access-class
interface-number |
service]
service
command to select the active access list.
mlist
1/e1
2/e9
mlist
mlist
1/e1
2/e9
mlist
vlan vlan-id | port-channel