Priority-Queue Out Num-Of-Queues - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
Parameters
• queue-id — Specifies the queue number to which the CoS values are
mapped.
• cos1...cos8 — Specifies CoS values to be mapped to a specific queue
(Range: 0-7).
Default Setting
There is no default configuration for this command.
Command Mode
Global Configuration mode
Command Usage
This command can be used to distribute traffic into different queues, where
each queue is configured with different Weighted Round Robin (WRR) and
Weighted Random Early Detection (WRED) parameters.
It is recommended to specifically map a single VPT to a queue, rather than
mapping multiple VPTs to a single queue. Use the
Configuration (Ethernet, Port-channel) mode command to enable expedite
queues.
Example
The following example maps CoS 7 to queue 2.
Console(config)# wrr-queue cos-map 2 7
Related Commands

priority-queue out num-of-queues

priority-queue out num-of-queues
The
priority-queue out num-of-queues
configures the number of expedite queues. To return to the default configuration,
use the form of this command.
no
Syntax
priority-queue out num-of-queues
no priority-queue out num-of-queues
Parameters
• number-of-queues — Specifies the number of expedite queues. Expedite
queues have higher indexes (Range: 0-4).
Default Setting
All queues are expedite queues.
Command Mode
Global Configuration mode
482
priority-queue out
Global Configuration mode command
number-of-queues
Interface