Power Inline Traps Enable - Alcatel OmniStack LS 6248 User Manual

Parameters
• percentage
measured power (Range: 1-99).
Default Setting
The default threshold is 95 percent.
Command Mode
Global Configuration mode
Command Usage
There are no user guidelines for this command.
Example
The following example configures the power usage threshold for which alarms are
sent to 80%.
Console(config)# power inline usage-threshold 80
Related Commands
power inline
power inline powered-device
power inline priority
show power inline

power inline traps enable

The
power inline traps enable
power traps. To disable inline power traps, use the
Syntax
power inline traps enable
no power inline traps
Default Setting
Inline power traps are disabled.
Command Mode
Global Configuration mode
Command Usage
There are no user guidelines for this command.
Example
The following example enables inline power traps to be sent when a power usage
threshold is exceeded.
Console(config)# power inline traps enable
Specifies the threshold as a percentage to compare
—
Global Configuration mode command enables inline
Power over Ethernet Commands
form of this command.
no
4
463