Ip Arp Inspection - Alcatel OmniStack LS 6248 User Manual

Default Configuration
This command has no default configuration.
Command Mode
EXEC mode
User Guidelines
Since the IP source guard uses the Ternary Content Addressable Memory
(TCAM) resources, there may be situations where IP source guard addresses
are inactive because of lack of TCAM resources.
By default, every minute the software conducts a search for available space in
the TCAM for the inactive IP source guard addresses.
The ip source-guard tcam retries-freq Global Configuration mode command
changes the frequency or disables automatic retries for TCAM space.
The ip source-guard tcam locate Privileged EXEC mode command retries
locating TCAM resources for the inactive IP source guard addresses.
This command displays the inactive IP source guard addresses.
Example
The following example displays the IP source guard inactive addresses.
Console# show ip source-guard inactive
TCAM resources search frequency: 10 minutes
Interface Filter
---------- ----------
- -
1/32 IP

ip arp inspection

The ip arp inspection Global Configuration mode command globally enables ARP
inspection. To disable ARP inspection, use the no form of this command.
Syntax
ip arp inspection
no ip arp inspection
Default Configuration
The default configuration is set to disabled.
Command Mode
Global Configuration mode
DHCP Snooping, IP Source Guard and ARP Inspection Commands
IP Address MAC
Address
---------- ----------
- -
10.1.8.32 0060.704C.
83FF
VLAN Type
---------- ----------
- -
3 3DHCP
4
Reason
----------
-
Resource
Problem
645