Clock Commands - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface

Clock Commands

.
Command
clock set
clock source
clock timezone
clock summer-time
sntp
authentication-key
sntp authenticate
sntp trusted-key
sntp client poll timer Sets the polling time for the Simple Network Time Protocol
sntp broadcast client
enable
sntp anycast client
enable
sntp client enable
(Interface)
sntp unicast client
enable
sntp unicast client
poll
sntp server
show clock
348
Table 4-11. Clock Commands
Function
Manually sets the system clock.
Configures an external time source for the system clock. Use no
form of this command to disable external time source.
Configures an external time source for the system clock. Use no
form of this command to disable external time source.
Configures the system to automatically switch to summer time
(daylight saving time). To configure the software not to
automatically switch to summer time, use the no form of this
command.
Defines an authentication key for Simple Network Time Protocol
(SNTP). To remove the authentication key for SNTP, use the no
form of this command.
Grants authentication for received Simple Network Time Protocol
(SNTP) traffic from servers. To disable the feature, use the no
form of this command.
Sets the amount of time the management console is inaccessible
after the number of unsuccessful logon attempts exceeds the
threshold set by the password-thresh command
(SNTP) client. To return to default configuration, use the no form
of this command.
Enables Simple Network Time Protocol (SNTP) broadcast clients.
To disable SNTP broadcast clients, use the no form of this
command.t
Enables SNTP anycast client. To disable the SNTP anycast client,
use the no form of this command.
Enables the Simple Network Time Protocol (SNTP) client on an
interface. This applies to both receive broadcast and anycast
updates. To disable the SNTP client, use the no form of this
command.
Enables the device to use the Simple Network Time Protocol
(SNTP) to request and accept SNTP traffic from servers. To
disable requesting and accepting SNTP traffic from servers, use
the no form of this command.
Enables polling for the Simple Network Time Protocol (SNTP)
predefined unicast servers. To disable the polling for SNTP client,
use the no form of this command.
Configures the device to use the Simple Network Time Protocol
(SNTP) to request and accept SNTP traffic from a specified
server. To remove a server from the list of SNTP servers, use the
no form of this command.
Displays the time and date from the system clock.
Mode Page
PE 4-349
GC 4-350
GC 4-350
GC 4-351
GC 4-353
GC 4-353
GC 4-354
GC 4-355
GC 4-356
GC 4-357
IC 4-357
GC 4-358
GC 4-359
GC 4-360
UE 4-361