Duplex - Alcatel OmniStack LS 6248 User Manual

back-pressure
show interfaces configuration
show interfaces status

duplex

The Interface Configuration (Ethernet) mode command configures the full/
duplex
half duplex operation of a given Ethernet interface when not using auto-negotiation.
To restore the default configuration, use the
Syntax
{ |
duplex half
Parameters
•
no duplex
• — Forces half-duplex operation
half
• full — Forces full-duplex operation
Default Setting
The interface is set to full duplex.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
When configuring a particular duplex mode on the port operating at 10/100
Mbps, disable the auto-negotiation on that port.
Half duplex mode can be set only for ports operating at 10 Mbps or 100 Mbps.
Example
The following example configures the duplex operation of Ethernet port 1/e5 to full
duplex operation.
Console(config)#
Console(config-if)#
Related Commands
shutdown
speed
negotiation
flowcontrol
mdix
back-pressure
show interfaces configuration
show interfaces status
}
full
interface ethernet
duplex full
Ethernet Configuration Commands
form of this command.
no
1/e5
4
381