Defining Poe Interfaces; Figure 3-64. Properties Page - Alcatel OmniStack LS 6248 User Manual

3
Configuring the Switch
fields and click Apply.
CLI – The following is an example of PoE properties commands:
Console(config)# power inline usage threshold 80
4-460
Console(config)# power inline traps enable
4-463
Console(config)# end
Console# show power inline
4-464
Power: On
Nominal Power: 150 Watt
Consumed Power: 120 Watts (80%)
Usage Threshold: 95%
Traps: Enabled

Defining PoE Interfaces

The PoE Interface Page contains information for configuring PoE interfaces,
including the interface PoE operation status and the interface's power consumption.
Command Attributes
• Port — Indicates the specific interface for which PoE parameters are defined and
assigned to the powered interface connected the to selected port.
• Admin Status — Indicates the device PoE mode. The possible field values are:
• Auto — Enables the Device Discovery protocol, and provides power to the
device using the PoE module. The Device Discovery Protocol enables the
device to discover Powered Devices attached to the device interfaces, and to
140

Figure 3-64. Properties Page