Spanning-Tree Link-Type - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
Default Setting
PortFast mode is disabled.
Command Modes
Interface Configuration (Ethernet, port-channel) mode
Command Usage
This feature should be used only with interfaces connected to end stations.
Otherwise, an accidental topology loop could cause a data packet loop and
disrupt device and network operations.
An interface with PortFast mode enabled is moved directly to the spanning tree
forwarding state when linkup occurs without waiting the standard forward-time
delay.
Example
The following example enables PortFast on Ethernet port 1/e15
Console(config)# interface ethernet 1/e15
Console(config-if)# spanning-tree portfast
Related Commands
spanning-tree forward-time
spanning-tree hello-time
spanning-tree max-age
spanning-tree priority
spanning-tree disable
spanning-tree cost
spanning-tree port-priority

spanning-tree link-type

show spanning-tree
spanning-tree link-type
The
spanning-tree link-type
default link-type setting determined by the duplex mode of the port and enables
Rapid Spanning Tree Protocol (RSTP) transitions to the forwarding state. To return
to the default configuration, use the
Syntax
spanning-tree link-type
no spanning-tree spanning-tree link-type
Parameters
•
point-to-point
548
Interface Configuration mode command overrides the
form of this command.
no
{
point-to-point
— Indicates that the port link type is point-to-point.
| }
shared
.