Ip Igmp Snooping Host-Time-Out; Ip Igmp Snooping Mrouter-Time-Out - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
Related Commands
ip igmp snooping querier enable
show ip igmp snooping groups

ip igmp snooping host-time-out

The ip igmp snooping host-time-out
command configures the host-time-out. If an IGMP report for a multicast group was
not received for a host-time-out period from a specific port, this port is deleted from
the member list of that multicast group. To return to the default configuration, use the
form of this command.
no
Syntax
ip igmp snooping host-time-out
Parameters
• no ip igmp snooping host-time-out
• time-out — Host timeout in seconds. (Range: 60 - 2147483647)
Default Setting
The default host-time-out is 260 seconds.
Command Mode
Interface Configuration (VLAN) mode
Command Usage
The timeout should be at least greater than
2*query_interval+max_response_time of the IGMP router.
IGMP snooping works on PVE protected ports; however forwarding of query/
reports is not limited to the PVE uplink.
Example
The following example configures the host timeout to 300 seconds.
Console(config)#
Console(config-if)#
Related Commands
ip igmp snooping querier enable

ip igmp snooping mrouter-time-out

The
ip igmp snooping mrouter-time-out
command configures the mrouter-time-out. The
Interface Configuration (VLAN) mode command is used for setting the aging-out
time after multicast device ports are automatically learned. To return to the default
configuration, use the
410
Interface Configuration (VLAN) mode
time-out
interface vlan
ip igmp snooping host-time-out
no form of this command.
2
Interface Configuration (VLAN) mode
ip igmp snooping mrouter-time-out
300