System Management Commands; Ping - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface

System Management Commands

Command
Clock Commands
traceroute
telnet
resume
reload
hostname
stack master
stack reload
stack display-order
show stack
show users
show sessions
show system
show version
service
cpu-utilization
show cpu utilization Displays information about CPU utilization.

ping

The User EXEC mode command sends ICMP echo request packets to another
ping
node on the network.
Syntax
{ip-address | hostname }[
ping
time_out]
Parameters
• ip-address — IP address to ping.
• hostname — Host name to ping. (Range: 1-158 characters)
• packet_size — Number of bytes in a packet. The actual packet size is eight
bytes larger than the specified size specified because the device adds
header information. (Range: 56 - 1472 bytes)
604
Table 4-31. System Management Commands
Function
Sends ICMP echo request packets to another node on the
network.
Discovers routes that packets actually take when traveling to their
destination.
Enables logging on to a host that supports Telnet.
Enables switching to another open Telnet session.
Reloads the operating system.
Specifies or modifies the device host name. To remove the
existing host name, use the no form of the command.
Enables forcing the selection of a stack master. To return to the
default configuration, use the no form of this command.
Reloads stack members.
Configures the order of the units in the display. To return to the
default configuration, use the no form of this command .t
Displays information about the status of a stack.
Displays information about the active users.
Lists open Telnet sessions.
Displays system information.
Displays system version information.
Enables measuring CPU utilization. To return to the default
configuration, use the no form of this command.
size
packet_size] [
count
Mode
UE
UE
UE
UE
PE
GC
GC
PE
GC
UE
UE
UE
UE
UE
GC
UE
packet_count] [
timeout
Page
4-348
4-606
4-608
4-611
4-612
4-612
4-613
4-614
4-614
4-615
4-617
4-617
4-618
4-619
4-620
4-621