Alcatel OmniStack LS 6248 User Manual page 278

4
Command Line Interface
To access the switch through a Telnet session, you must first set the IP address for
the switch, and set the default gateway if you are managing the switch from a
different IP subnet. For example,
Console(config)#interface vlan 1
Console(config-if)#ip address 10.1.0.254 255.255.255.0
Console(config-if)#exit
Console(config)#ip default-gateway 10.1.0.254
If your corporate network is connected to another network outside your office or to
the Internet, you need to apply for a registered IP address. However, if you are
attached to an isolated network, then you can use any IP address that matches the
network segment to which you are attached.
After you configure the switch with an IP address, you can open a Telnet session by
performing these steps:
1. From the remote host, enter the Telnet command and the IP address of the
device you want to access.
2. At the prompt, enter the user name and system password.
3. Enter the necessary commands to complete your desired tasks.
4. When finished, exit the session with the "quit" or "exit" command.
After entering the Telnet command, the login screen displays:
Username: admin
Password:
CLI session with the OmniStack 6300-24 is opened.
To end the CLI session, enter [Exit].
Note: You can open up to four sessions to the device via Telnet.
254