4
Command Line Interface
Syntax
mdix {on | auto}
no mdix
Parameters
•
— Manual mdix
on
•
— Automatic mdi/mdix
auto
Default Setting
The default is
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
All possibilities to connect a PC with cross or normal cables are
Auto:
supported and are automatically detected.
: It is possible to connect to a PC only with a normal cable and to connect
On
to another device only with a cross cable.
No: It is possible to connect to a PC only with a cross cable and to connect to
another device only with a normal cable.
Example
In the following example, automatic crossover is enabled on port 1/e5.
Console(config)#
Console(config-if)#
Related Commands
shutdown
speed
duplex
negotiation
flowcontrol
back-pressure
show interfaces configuration
show interfaces status
back-pressure
The
back-pressure
back pressure on a given interface. To disable back pressure, use the
command.
384
.
on
interface ethernet
mdix auto
Interface Configuration (Ethernet ) mode command enables
1/e5
form of this
no