Ip Igmp Snooping Map Cpe Vlan - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
Syntax
switchport customer multicast-tv vlan
• vlan-list — List of Multicast TV VLANs.
Default Setting
The port is not member in any multicast TV VLAN.
Command Mode
Interface configuration (Ethernet, port-channel)
Command Usage
The user cannot transmit Multicast transmissions on Multicast TV VLANs.
Example
The following example configure port e1 to enable receiving multicast transmissions
from a VLAN that is not the customer port's VLAN.
Console (config-if)# switchport customer multicast-tv vlan add 3000
Related Commands

ip igmp snooping map cpe vlan

show ip igmp snooping cpe vlans
ip igmp snooping map cpe vlan
The
ip igmp snooping map cpe vlan
VLANs to multicast-TV VLANs. Use the
mapping.
Syntax
ip igmp snooping map cpe vlan
no ip igmp snooping map cpe vlan
Parameters
• cpe vlan
•
multicast-tv vlan
Default Setting
No mapping exists.
Command Mode
Global configuration
Command Usage
Use this command to associate CPE VLAN to a multicast-TV VLAN.
If an IGMP message is received on a customer port tagged with a CPE VLAN,
and there is a mapping from that CPE VLAN to a multicast-TV VLAN, the
IGMP message would be associated with the multicast-TV VLAN.
628
global configuration command maps CPE
vlan-id — Specify the CPE VLAN.
vlan-id —Specify the Multicast VLAN.
{ vlan-list |
add
form of this command to remove the
no
vlan-id
multicast-tv vlan
vlan-id
vlan-list}
remove
vlan-id