Dot1X Single-Host-Violation - Alcatel OmniStack LS 6248 User Manual

Example
The following command enables multiple hosts (clients) on an 802.1X-authorized
port.
Console(config-if)#
Related Commands

dot1x single-host-violation

show dot1x advanced
dot1x single-host-violation
The
dot1x single-host-violation
the action to be taken, when a station whose MAC address is not the supplicant
MAC address, attempts to access the interface. Use the
return to default.
Syntax
dot1x single-host-violation
seconds]
no port dot1x single-host-violation
Parameters
• — Forwards frames with source addresses that are not the
forward
supplicant address, but does not learn the source addresses.
• — Discards frames with source addresses that are not the
discard
supplicant address.
•
discard-shutdown
the supplicant address. The port is also shut down.
• — Indicates that SNMP traps are sent.
trap
• seconds — Specifies the minimum amount of time in seconds between
consecutive traps. (Range: 1- 1000000
Default Setting
Frames with source addresses that are not the supplicant address are
discarded.
No traps are sent.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
The command is relevant when multiple hosts is disabled and the user has
been successfully authenticated.
dot1x multiple-hosts
Interface Configuration mode command configures
{ |
forward
— Discards frames with source addresses that are not
form of this command to
no
|
discard discard-shutdown
)
802.1x Commands
} [
trap
283
4