Traceroute - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
64 bytes from 10.1.1.1: icmp_seq=0. time=11 ms
64 bytes from 10.1.1.1: icmp_seq=1. time=8 ms
64 bytes from 10.1.1.1: icmp_seq=2. time=8 ms
64 bytes from 10.1.1.1: icmp_seq=3. time=7 ms
----10.1.1.1 PING Statistics----
4 packets transmitted, 4 packets received, 0% packet loss
round-trip (ms) min/avg/max = 7/8/11
Related Commands
resume

traceroute

The User EXEC mode command discovers routes that packets actually
traceroute
take when traveling to their destination.
Syntax
{ip-address |hostname }[
traceroute
packet_count] [
Parameters
• ip-address — IP address of the destination host.
• hostname — Host name of the destination host. (Range: 1-158 characters)
• packet_size — Number of bytes in a packet. (Range: 40-1500)
• max-ttl — The largest TTL value that can be used. The
command terminates when the destination is reached or when this value is
reached. (Range:1-255)
• packet_count — The number of probes to be sent at each TTL level.
(Range:1-10)
• time_out — The number of seconds to wait for a response to a probe
packet. (Range:1-60)
• ip-address — One of the device's interface addresses to use as a source
address for the probes. The device normally selects what it feels is the best
source address to use.
• tos — The Type-Of-Service byte in the IP Header of the packet.
(Range: 0-255)
Default Setting
The default number of bytes in a packet is 40.
The default maximum TTL value is 30.
The default number of probes to be sent at each TTL level is 3.
The default timeout interval in seconds is 3.
Command Mode
User EXEC mode
606
timeout time_out] [
packet_size] [
size
source ip-address] [
max-ttl] [
ttl count
tos tos]
traceroute