Power Over Ethernet Commands; Power Inline - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface

Power over Ethernet Commands

Command

power inline

power inline
powered-device
power inline priority Configures the inline power management priority of the interface.
power inline
usage-threshold
power inline traps
enable
show power inline
.
power inline
The Interface Configuration (Ethernet) mode command configures the
port inline
administrative mode of inline power on an interface.
Syntax
power inline {auto | never}
Parameters
•
auto —
to the device.
•
never —
to the device.
Default Setting
The device discovery protocol is enabled.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
There are no user guidelines for this command.
Example
The following example enables powered device discovery protocol on port 1/e1, so
that power will be supplied to a discovered device.
Console(config)#
Console(config-if)#
460
Table 4-23. Power over Ethernet Commands
Function
Configures the administrative mode of inline power on an
interface.
Adds a comment or description of the powered device type to
enable the user to remember what is attached to the interface. To
remove the description, use the no form of this command.
To return to the default configuration, use the no form of this
command.
Configures the threshold for initiating inline power usage alarms.
To return to the default configuration, use the no form of this
command.
Enables inline power traps. To disable inline power traps, use the
no form of this command.
Displays the information about inline power.
Enables the device discovery protocol and, if found, supplies power
Disables the device discovery protocol and stops supplying power
interface ethernet
power inline auto
1/e1
Mode Page
ICE 4-376
ICE 4-459
ICE 4-462
GC 4-462
GC 4-463
UE 4-464